Installing the Module 2 - 5
Installing the RMON MultiProbe Module
You do not need to power down the hub to install or remove the RMON
MultiProbe Module. You can insert the module while the hub is operating
(this is called a hot swap).
To install the RMON MultiProbe Module:
1. Properly ground yourself prior to handling the module.
For example, wear a static wrist guard or touch a grounded static
mat prior to handling the module.
2. Locate an open slot in the hub. Remove a blank panel on the hub to
expose a slot for the module, if necessary.
3. Insert the module into the board guides at the top and bottom of the
slot and slide it into the hub by pressing firmly at the top and bottom
of the faceplate. Make sure the connectors are well-seated into the
backplane of the hub.
Once you install the module, it automatically begins self-diagnostics
and initializes.
