Chapter 6: First-Level Commands June 30, 2006
6-34 SG1-UM-8500-03
USING DEBUG MODE
This section provides information on the commands and options available in debug mode.
Switching to Debug Mode
Use the debug command at the first-level prompt (Host>) to switch the system to the second-level debug prompt:
Host(debug)#. This prompt indicates that the user is now in the second-level debug mode and has access to the
five second-level commands in the debug menu.
Usage
Parameter(s)
None.
Example(s)
Host> debug
Step Action
1Use the show command to display memory, system and fragmentation information.
2The port sonet source-clock command determines timing configuration for the ATM port specified.
3 At this level, the exit and end commands will return the user to the first configuration level.
4 From the Host> prompt, enter the debug command in the following format:
debug
Host(debug)# ?
show - Display debug parameters
port - Select a port to configure
port-ethernet - Port ethernet interface
radius-server - radius server command
clear - Clear arp table
exit - Exit current level
end - Return to first level
Host(debug)#
