98 Chapter 10 Working With NetBoot Service
Changing NetBoot Settings
You can change NetBoot service settings using the serveradmin command.
To change a setting:
$ sudo serveradmin settings netboot:setting = value
To change several settings:
$ sudo serveradmin settings
netboot:setting
= value
netboot:setting = value
netboot:setting = value
[...]
Control-D
NetBoot Service Settings
General Settings
Use the following parameters with the serveradmin command to change settings for
the NetBoot service.
Parameter Description
setting
A NetBoot service setting. To see a list of available settings, type
$ sudo serveradmin settings netboot
or see “NetBoot Service Settings” on this page.
value
An appropriate value for the setting.
Parameter (netboot:) Description
filterEnabled Specifies whether client filtering is enabled.
Default = "No"
netBootStorageRecordsArray... An array of values for each server volume used to store
boot or install images. For a description, see “Storage
Record Array” on page 99.
netBootFiltersRecordsArray... An array of values for each computer explicitly allowed
or disallowed access to images. For a description, see
“Filters Record Array” on page 99.
netBootImagesRecordsArray... An array of values for each boot or install image stored
on the server. For a description, see “Image Record
Array” on page 100.
netBootPortsRecordsArray... An array of values for each server network port used to
deliver boot or install images. For a description, see
“Port Record Array” on page 101.
LL2354.book Page 98 Monday, October 20, 2003 9:47 AM
