Note: Wireless performance may degrade if select ID channel is already being occupied by
other AP(s).
TX PowerLevel: It is a function that enhances the wireless transmitting signal strength. User
may adjust this power level from minimum 1 up to maximum 127.
Note: The Power Level maybe different in each access network user premises environment
and choose the most suitable level for your network.
Connected: Representing in true or false. That it is the connection status between the system
and the build-in wireless card.
AP MAC Address: It is a unique hardware address of the Access Point.
AP Firmware Version: The Access Point rmware version.
Wireless Distribution System (WDS)
It is a wireless access point mode that enables wireless link and communication with other access
point. It is easy to be installed simply to dene peer’s MAC address of the connected AP. WDS takes
advantages of cost saving and flexibility which no extra wireless client device is required to bridge
between two access points and extending an existing wired or wireless infrastructure network to
create a larger network. It can connect up to 4 wireless APs for extending cover range at the same
time.
In addition, WDS enhances its link connection security in WEP mode, WEP key encryption must be
the same for both access points.
WDS Service: The default setting is Disabled. Check Enable radio button to activate this
function.
Peer WDS MAC Address:1. It is the associated AP’s MAC Address. It is important that your
peer’s AP must include your MAC address in order to acknowledge and communicate with
each other.
Peer WDS MAC Address:2. It is the second associated AP’s MAC Address.
Peer WDS MAC Address:3. It is the third associated AP’s MAC Address.
Peer WDS MAC Address:4. It is the fourth associated AP’s MAC Address.
Note: For MAC Address, Semicolon ( : ) must be included.
41
