Document: - page 7 (Black)
Screen angle and frequency: 45.0000, 150.0000
7
OIL
275064
CAUTION:
This engine is shipped from Briggs & Stratton without
oil. Check oil level before starting engine. If you start the
engine without oil, the engine will be damaged beyond
repair and will not be covered under warranty. Do not
overfill.
OIL CAPACITY
Engine holds approximately 3 ounces (90 ml).
TYPE OF OIL TO USE
• Use a high quality detergent oil classified “For Service
SF, SG, SH, SJ” or higher, such as Briggs & Stratton
SAE 30, Part Number 100005 (20 oz) or Briggs &
Stratton Synthetic Oil, Part Number 100074.
• Do not use special additives.
Note: Synthetic oil meeting ILSAC GF-2, API certifica-
tion mark and API service symbol (shown at left) with “SJ/
CF ENERGY CONSERVING” or higher, is an acceptable
oil at all temperatures. Use of synthetic oil does not alter
required oil change intervals.
°F
-20 0 20 40 60 80 100
°C
-30 -20 -10 0 10 20 30 40
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
**
32
CAUTION: Air cooled engines run hotter than
automotive engines. The use of non-synthetic
multi-viscosity oils (5W-30, 10W-30, etc.) in
temperatures above 40° F (4° C) will result in higher
than normal oil consumption. When using a
multi-viscosity oil, check oil level more frequently.
* CAUTION: Synthetic oil must be used when
operating engine under 40° F (4° C) or engine
damage will occur.
** CAUTION: SAE 30 oil, if used below 50° F
(10° C), will result in hard starting and possible
engine bore damage due to inadequate
lubrication.
SAE Viscosity Grades
*
ADDING OIL
CAUTION: KEEP ENGINE LEVEL
Engine must be level, with oil fill facing up, to check
oil. If engine is not level, dipstick reading will not be
accurate. This will lead to possible over or under
filling causing damage to the engine.
• Check oil level before starting the engine.
• Check oil level before every use.
• Keep oil level at FULL.
• DO NOT overfill, use oil measure cup for filling.
• Add only 1 oz. – 0.5 oz. of oil at a time.
1 ounce
0.5 ounce
See also Changing Oil and
Checking Level under Maintenance Section.
OIL FILL
DIPSTICK
1. Place engine level. Re-
move dipstick. Using oil
measure cup pour oil
slowly. Do not overfill.
2. Tighten dipstick down.
3. To check oil level, remove
dipstick and wipe clean
with cloth. Tighten dip-
stick down. Remove &
check oil level.
4. Verify FULL level of oil by
presence of oil in hole on
dipstick, or by measure
line.
5. If needed, add 0.5 oz. oil
at a time to bring it to
FULL. Recheck level.
FULL
Note: Engine holds
approximately
3 oz. (90 ml)
