ESX-1320/ESX-1380 Installation Guide 3-1
CHAPTER 3
INSTALLATION
This chapter provides the instructions to install and connect the ESX to
the network. It includes the following procedures:
• Unpacking the ESX (Section 3.1)
• Removing the chassis cover (Section 3.2)
• Locating and setting the mode switches (Section 3.3)
• Using the NVRAM reset switch (Section 3.4)
• Adding/replacing Single In-line Memory Modules (SIMMs)
(Section 3.5)
• Identifying the BRIM connector location (Section 3.6)
• Installing the ESX on a shelf or into a standard rack (Section 3.7)
• Pre-network installation testing (Section 3.8)
• Connecting to a network (Section 3.9)
Only qualified personnel should perform installation
procedures.
NOTE
For information on how to install an optional BRIM, refer to your
specific BRIM documentation.
