Page 4SKU 96147
For technical questions, please call 1-800-444-3353.
ASSEMBLY
Screw the Pump Elbow (3) into the Air Pump (4) and tighten.
Connect the Air Hose (2) to the Pump Elbow (3).
Connect the other end of the Air Hose to the Air Valve Body (1.6)
Connect the two pipe Handles (5, 6) together.
Check level of hydraulic oil, fill if necessary (See “Oil Replacement” section of manual
for directions).
OPERATION
Lifting
Test Jack to ensure proper working condition before use, raise and lower ram to see if
operation is smooth and without hitch.
Place the slotted end of the Lower Handle (6) over the Release Valve Screw (18). Turn
the Valve Release screw clockwise until snug. (See FIGURE A)
Place the Jack into position under the load.
Check manufacturer’s manual of vehicle or other item being lifted to find the recom-
mended lifting points.
Adjust the Extension Screw (44) as needed, turn counterclockwise to raise, clockwise
to lower.
Insert the large end of the Handle assembly into the Handle Sleeve (7).
Connect the air supply hose lock fitting into the Hose Connector (1.1).
The Lever (1.13) should be Off (not in the locked position).
Press the Lever (1.13) to the On position and lock using the Lock Lever (1.17).
Raise the Jack by alternately lifting and lowering the Handle assembly or by depress-
ing Lever (1.13).
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
