ip pim spt-threshold
To switch to the shortest path tree when the traffic reaches the specified threshold value, configure the
PIM router.
S6000
Syntax
ip pim [vrf vrf-name] spt-threshold [infinity]
To return to the default value, use the no ip pim [vrf vrf-name] spt-
threshold [infinity] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure the PIM router on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
infinity (OPTIONAL) Enter the keyword infinity to never switch to
the source-tree.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
Usage
Information
This command is applicable to last hop routers on the shared tree towards the
rendezvous point (RP).
show ip pim bsr-router
View information on the Bootstrap router.
S6000
Syntax
show ip pim [vrf vrf-name] bsr-router
PIM-Sparse Mode (PIM-SM)
1203
