Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S6000, S4810, S4820T, Z9000.
Usage
Information
A value of 0 copies the inner packet hop limit (ipv6) or time-to-live (ipv4) in the
encapsulated packet to the tunnel header hop limit (ipv6) or time-to-live (ipv4)
value.
tunnel destination
Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
ipv6–address Enter the destination IPv6 address for the tunnel.
Defaults none
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage
Information
The tunnel interface is inoperable without a valid tunnel destination address for the
configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the
destination address of the outer tunnel header. If you configure a tunnel interface
or source address, the tunnel destination must be compatible.
Tunneling
1591
