DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
129
DES-3526:admin#show access_profile
Command: show access_profile
Access Profile Table
Access Profile ID : 1
Type : Packet Content Filter
Owner : Address_binding
Masks :
Offset 0-15 : 0x00000000 0000ffff ffffffff
00000000
Offset 16-31 : 0x00000000 00000000 00000000 0000ffff
Offset 32-47 : 0xffff0000 00000000 00000000 00000000
Offset 48-63 : 0x00000000 00000000 00000000 00000000
Offset 64-79 : 0x00000000 00000000 00000000 00000000
Access ID : 1
Mode : Permit
Owner : Address_binding
Port : 1
------------------------------------------------------------
Offset 0-15 : 0x00000000 0000ffff ffffffff
00000000
Offset 16-31 : 0x00000000 00000000 00000000 0000ffff
Offset 32-47 : 0xffff0000 00000000 00000000 00000000
Offset 48-63 : 0x00000000 00000000 00000000 00000000
Offset 64-79 : 0x00000000 00000000 00000000 00000000
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
The show access_profile command will display the two access profiles created and their corresponding rules for every port on the
Switch.
config address_binding ip_mac ipaddress
Purpose Used to configure an IP-MAC Binding entry.
Syntax
config address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all] | mode {arp | acl]}
Description This command will configure an IP-MAC Binding entry.
Parameters
<ipaddr> - The IP address of the device where the IP-MAC binding is
made.
<macaddr> - The MAC address of the device where the IP-MAC binding
is made.
<portlist> - Specifies a port or range of ports to be configured for address
binding.
all – Specifies that all ports on the switch will be configured for address
binding.
mode – The user may set the mode for this IP-MAC binding settings by
choosing one of the following:
arp - Choosing this selection will set a normal IP-MAC Binding entry for
the IP address and MAC address entered.
acl - Choosing this entry will allow only packets from the source IP-MAC
binding entry created here. All other packets with a different IP
address will be discarded by the Switch. This mode can only be
used if the ACL Mode has been enabled in the IP-MAC Binding
Ports window as seen previously.
Restrictions User Account Command Level – Administrator and Operator.
Example usage:
To configure address binding on the Switch:
