D-Link DHS-3224V Switch User’s Guide
63
Configure Radius Server
Select Configure Radius Server on the PAE Configuration menu and press Enter to access the following
screen:
Figure 6- 27. Configure Radius Server menu
This menu offers three configuration choices for the radius server.
Figure 6- 28. Configure General Radius Server Setting screen
This screen allows you to set the following features:
• AuthProtocol: <Radius Server(Support EAP)> – Toggle between the authentication protocol options:
Radius Server(Support EAP) and Local.
• Radius Dead Time:[1 ] –This specifies the number of minutes a RADIUS server which is not
responding to authentication requests is considered unavailable and is passed over by further requests
for RADIUS authentication.
• Radius Time Out:[10 ] – This specifies the number of seconds NAS waits for a reply to a RADIUS
request before transmitting the request.*
• Radius Maximum Retransmit:[2 ] –This specifies the number of times NAS transmits each RADIUS
request to the server before giving up.*
• Accounting Method:<Radius Server> – To use a RADIUS Server, toggle from None to Radius Server.
