510 with
Components 510 Basic Zone 610 810 910
Interlock
Trip Unit
Rating Plug
Auxiliary Current
Transformer
(CT) Module
Auxiliary
CT Harness
Sensors
Sensor Harness
Direct Trip
Actuator (DTA)
Mounting Brackets
and Hardware
External Plug 1 Connector 2 Connector 4 Connector 4 Connector
Harness Harness Harness Harness Harness
Cell Harness
Potential Transformer
(PT) Module
Auxiliary Switch
Effective December, 1998
IL 33-FC6-1
Page 2
Cutler-Hammer Digitrip Retrofit Kits are available
in a number of configurations that provide a wide
range of features. The Digitrip System starts with
the 510 Basic Kit which offers true RMS sensing,
overcurrent protection, and self-testing features.
Advanced Digitrip Retrofit Kits feature zone
interlocking, digital alphanumeric displays, remote
alarm signals, IMPACC communications, energy
monitoring capabilities, power factors, and
harmonic content measurements.
The following table provides a quick reference of
the components supplied with each level of Retrofit
Kit. Before beginning the Retrofit process, take a
minute to review the information contained in the
table. It is important that the Retrofitter understand
which level of Retrofit Kit is to be installed and
which components are included with the Kit.
The instructions contained in this manual cover the
installation of all levels of Retrofit Kit. If the Kit you
are installing does not contain a certain compo-
nent, skip the instructions for that component and
proceed to the next.
Throughout the Retrofit process, refer to the
Torque Tables at the back of this manual for
specific torque values.
If you have any questions concerning the Retrofit
Kit and / or the Retrofit process, contact
Cutler-Hammer at 1-800-937-5487.
