7
USING THE AMCAP SOFTWARE:
1. Turn on your computer.
2. After Windows
®
has loaded; click “Start”, then select “All Programs” (for Windows
®
2000
users, select “Programs”), then select “PC Camera PAC7302”, and then click “AMCap” to
start the AMCAP software.
3. If this is the first time you have run the AMCAP software, it may not show the video signal
from your Webcam automatically. To show the video signal for your Webcam manually,
click “Options”, and then click “Preview”.
4. Within a short moment, the video signal from your Webcam will show in the AMCAP screen.
Adjusting Lens Focus
Depending on the distance between you and your Webcam, the video signal from your Webcam
may be out of focus and you may have to adjust the lens focus manually. To adjust the lens focus
manually, please turn the focus knob on your Webcam as shown below.
Taking a Snap Shot
1. Make sure your computer is turned on and you have installed and connected your Webcam
to your computer.
2. Press the “Snapshot” button on your Webcam.
3. If the AMCAP software is not running, it will start up automatically. Press the “Snapshot”
button again to take a snapshot. If the AMCAP software is already running, a snapshot will
be taken immediately after you press the “Snapshot” button on your Webcam.
4. The captured snapshot will be opened in the “SnapShot Reader” screen. The captured
snapshot is not saved automatically; please make sure you save it manually before closing
the “SnapShot Reader” screen. To save the snapshot, click “File”, then click “Save” and to
save the file to a specified location.
