Hewlett-Packard 800 Manual

A SERVICE OF

next previous

Expanding the OmniBook

Replacing Internal Hardware

3-5

5. Important: Disengage the hard drive connectors by grasping the left flap of the

plastic insulator and pulling to the right as shown.

6. CAUTION: Handle the hard drive only by its edges to avoid damage from

electrostatic discharge .

Lift up on the left flap of the insulator sheet and remove the hard drive. The

insulator sheet stays in place.

7. Important: If your new hard drive is from a different manufacturer than the old

one, it may have screws in different positions. Determine which mounting holes

you need; then, if necessary, push out rubber screw-hole covers from the inside

using a bent paper clip. (From the outside of the computer, insert the rubber

covers into the holes you won’t need.)