87
Chapter 7 Replacing Parts
6. Replace the upper bezel.
7. Replace the left side cover.
8. Replace the external cables and power cord.
9. Power on the server as described in Chapter 1‚ Controls and Indicators.
Removing a Hard Disk Drive (Drive Cage Mounted)
The replacement of the mass storage cage mounted drives is the same for IDE or SCSI devices. The first hard
disk drive (IDE or SCSI) is always mounted in the top (shelf 5) of the hard disk drive cage. The second hard
disk drive should be mounted just below it (shelf 6).
1. If the server is operating, power down the server.
Refer to Chapter 1‚ Controls and Indicators for instructions.
2. Disconnect the power cord and any external cables connected to the server.
If necessary, label each one to expedite re-assembly.
3. Remove the left side cover.
4. Disconnect the data and power connectors from the drive.
5. Press and release the retaining clips at the side of the drive cage.
NOTE If this is the initial installation of a hard disk drive in this
location, it is necessary to remove the bezel drive cover from
the upper front bezel.
CAUTION Install and remove connectors carefully, and avoid
displacing any pins.
