Ch 2: System Environment Setting
Hitachi VisionBase 8880R Server 31
Console Redirection (Unsupported)
•
Com Port Address
Use the default “Disabled”.
NOTE:
If you set “Serial port 1” in “Com Port Address”, the value set in “Base I/O address/IRQ” will be reflected.
•
Baud Rate
Use the default “19.2K”.
•
Flow Control
Use the default “XON/XOFF”.
Ext MP Configuration Table
Used to set the extended multiprocessor configuration table. Be sure to leave the default “Disabled” as is.
•
Disabled (default)
•
Enabled
I/O APIC Mode
Used to set I/O APIC mode. Be sure to leave the default “Single” as is.
•
Single: One I/O APIC is used (default)
•
Multiple: Two or more I/O APICs are used
Enable memory gap
Used to specify whether or not to use part of memory addresses (memory gap) for extended boards. Use the default
“Disabled”.
•
Disabled: Not to be used on extended boards (default)
•
Enabled: To be used on extended boards
PCI Data Parity
Used to set parity check for PCI bus. In ordinary circumstances, use the default setting “Enabled”.
•
Enabled: Conducts a parity check (default)
•
Disabled: Conducts no parity check
NOTE:
Installation of a PCI board without parity capability might cause a parity error. If such an error occurs, set
“Disabled” in “PCI Data Parity”.
Standard Memory Test
Used to specify whether or not to conduct a memory check at the startup of the system equipment. In ordinary
circumstances, use the default setting.
•
Fast Test: Conducts fast memory check
•
Normal Test: Conducts normal memory check
•
Disabled: Conducts no memory check
