6
Chapter 2 - Ironing
Dry Ironing
For dry ironing, turn the variable steam control knob all the way to the right to “0”.
This will cut o the steam ow if water is in the water tank.
Press on the temperature set buon to select the desired fabric/temperature seng,
posion the iron vercally on a smooth and stable area.
When the iron reaches the selected temperature, you can begin to iron.
Steam Ironing
As indicated on the temperature control and the table on the iron, steam-ironing is
only possible at higher ironing temperatures: “●●●” or “MAX”.
Ensure that there is enough water in the water tank.
Stand the iron on its end; Insert the mains plug into the wall socket.
Set the temperature set buon at the required posion within the steam area.
Remove the mains plug from the wall socket when the temperature seng process
shows error status.
Wait for the solepate to cool then plug the iron in again.
If the LCD panel sll shows error status, return the enre appliance to the nearest
service centre for examinaon and /or repair.
NOTE: Aer using the temperature seng buon, the backlight of LCD will become
duller. If the buon is not pressed within 30 seconds.
Aer 1 minute, the auto shut o will acon and the LCD backlight will go o.
Chapter 2.1 - Shot of Steam
Make sure the water tank is at least 1/2 lled with water.
When the iron temperature is set to a steam seng (more than level 6), a strong ow
of steam will be emied.
Press the steam boost buon, the soleplate will spray out a strong steam.
The burst steam feature can be used with Dry or Steam ironing as desired.
ATTENTION:
Do not aim iron at face, towards yourself, or anyone else while using or adjusng
steam. Burns or serious injury may occur.
LCD display
Normal status:
Error status:
Level 4 Level 5 Level 3 Level 2 Level 1 Stand by
Auto shut o
Level 6 Level 9 Level 8 Level 7
Malfuncon1 Malfuncon2
Malfuncon3
