7
Chapter 2.3 - Vercal Shot of Steam
Chapter 2.4 - Automac An-Calc Funcon
Chapter 2.5 - Automac An-Drip Funcon
Chapter 2.6 - Self Clean Funcon
When the iron temperature is set to steam seng vercal steam can be used.
Simply hold the iron vercally, posioned in front with a slight distance from the item
to be steamed, and press the steam boost buon.
ATTENTION: Do not aim iron at face, towards yourself, or anyone else while using or
adjusng steam. Burns or serious injury may occur.
NOTE: This is especially useful for geng wrinkles out of hanging clothes, curtains,
wall hangings etc.
Your iron contains an an-calc cartridge to reduce scale deposits. This considerably
prolongs the operaonal life of your iron.
The an-calc cartridge is an integral part of the water tank and dose not needs to be
replaced.
Your iron has an-drip funcon. The iron automacally stops generang steam when
the temperature is too low to prevent water from dripping out of the soleplate.
Use the self clean funcon once every two weeks. If the water in your area is very
hard, the self clean funcon should be used more frequently.
Make sure the iron is unplugged.
Set the steam control knob to posion “0”.
Fill the water tank to the maximum level.
Put the plug in the wall socket.
Select the maximum ironing temperature.
Unplug the iron when the temperature has reached.
Hold the iron over the sink, press and hold the self clean buon and gently shake the
iron to and fro.
Release the self clean buon aer 5-10seconds.
Repeat the self clean process if the iron sll contains a lot of impuries.
Chapter 2.2 - Spraying
Ensure there is enough water in the water tank.
Press the spray burst buon to produce a ne spray of water nozzle and connue
ironing.
NOTE: Do not spray silk.
Only use the steam boost buon when the steam iron has reached the steam or
maximum temperature.
Do not press this steam boost buon more than 3 mes repeatedly . For opmal steam
output, leave an interval of at least ve seconds between pressing the steam boost
buon .
