Invacare SP Manual

A SERVICE OF

next previous

SECTION 5—WHEELCHAIR OPERATION

Part No 1143190 45 TDX™ SP

Repositioning Joystick

Van Seats

NOTE:Forthisprocedure,refertoFIGURE 5.9.

NOTE:Takenoteofpositionandorientationofmountinghardwareforreinstallingthejoystick

assembly.

1. Turntheadjustmentlocklevertoreleasethejoystickmountingtubefromthe

mountingbracket.

2. Remove thejoystickmountingtubefromthewheelchair.

3. Remove thethreehexmountingscrews,bushingsandlocknutsthatsecurethe

mountingbrackettothethreemountingholesonthearmrestplate.

NOTE:Themountingbracketismountedtotheinsideofthearmrestplate.

4. Repositionthemountingbracketontheoppositearmrestplate.

5. Usingthethreehexmountingscrews,bushingsandlocknutssecurethemounting

brackettothethreemountingholesofthearmrestplate.

6. Ifnecessary,performthefollowingtorepositiontheadjustmentlock:

A. Slidetheadjustmentlockfromthemountingbracket.

B. Rotateadjustmentlock180°andslideadjustmentlockovertheoppositeendofthe

mountingbracket.

7. Slidejoystickmountingtubethroughthemountingbrackettothedesiredposition

andsecureadjustmentlocktotubebyturningleveronadjustmentlock.

FIGURE 5.9 Repositioning Joystick - Van Seats

Locknuts

Bushings

Armrest Plate

Mounting Bracket

Hex Mounting Screws

Adjustment Lock Lever

Joystick Mounting Tube

NOTE:Joystick 

notshown.