31
This section describes procedures to setup an IP address for
this unit and connect to the camera network (LAN1) and
monitoring PC (LAN2).
ⅷ Also setup an IP address for each of LAN1 and LAN2.
● Install and setup network cameras before network setup
for this unit.
1 Click the [Start] button on the desktop, followed
by clicking [Control Panel]
The control panel opens up.
2 Click [Network and Internet]
● If [Category] is not displayed, select [Category].
The [Network and Internet] window appears.
3 Click [Network and Sharing Center]
4 Click [Change adapter settings]
5 Right click on an adapter and click [Properties].
● To setup LAN1: Select AIntel(R) 82578DM Gigabit
Network Connection.”
● To setup LAN2: Select ARealtek RTL8168D/8111D
Family PCI-E Gigabit Ethernet NIC (NDIS 6.20).”
6 Select [Internet Protocol Version 4 (TCP/IPv4)]
and click [Properties]
Connect This Unit to a
Network
