49
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
AHIX
(Not to scale)
DOMED SKYLIGHT ASSEMBLY
SEC
SEC
Use a plain screwdriver to gently remove any excess plastic from the twelve holes in the Roof Panel for Domed
Skylight (AHB). It’s important that the hole stay square; try not to round the corners of the edges of the holes.
Note: Use a plain screwdriver to remove any excess plastic from
all holes in Panel. Ensure the holes remain square.
Note: Butyl Tape must overlap at ends and cover all twelve holes.
!
!
Start applying Butyl Tape here over
the holes along the groove and move
clockwise around the opening. Ensure
all holes are completely covered.
AHB
Stick the end of the Butyl Tape (AHI) over the groove and top, left hole of the Roof Panel for Domed Skylight as
indicated below. Move to the right and over the groove covering all the holes along the top of the opening. Once
the top, right corner and hole are covered, cut the Butyl Tape. Run your fi nger along the paper backing pressing
down slightly to remove any gaps or bubbles between the Butyl Tape and the groove. Remove the paper backing
from the piece you just applied. Overlap the end of the roll of Butyl Tape with the end you just cut and apply the
Butyl Tape over the holes along the groove on the right of the opening. Continue applying the Butyl Tape in this
fashion until all holes have been covered and the ends overlap.
8.1
8.2
8
