A SERVICE OF

logo

58
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
10
AGQ
AFLX
AFL
AFL
AFL
(Not actual size)
ADZX
SEC
10.3
SEC
10.4
7ITHTHE2OOF0ANELFOR$OMED3KYLIGHTINPOSITIONBETWEENTHE'ABLEAND4RUSSSLIDETWORoof Supports (AFL)
into place within the notches of the Roof Panel for Domed Skylight. The bottom lip of the Roof Panel fits over the
Wall Panel. The top of the Wall Panel fits into the groove near the bottom of the Roof Panel.
After aligning the holes in the Roof Panel WITHTHOSEINTHE7ALL0ANELS4RUSSAND'ABLESECURETHE2OOF0ANEL
for Domed Skylight to the shed using the required hardware. Then, secure a Roof Panel (AGQ) and one (1) Roof
Support (AFL) to the rear of the shed.
Note: Ensure the ridge in the bottom of the Roof Panel fits into the top of the wall.
Note: Roof Panels for Domed Skylights require two (2) Roof Support Strips, while
regular Roof Panels require only one (1) Roof Support Strip.
Note: The holes in the Roof Support Strips are for manufacturing
purposes only.
!
!
!
Interior Upward View