A SERVICE OF

logo

Open as PDF
next previous
6
Gently form the AR Interconnect Cable from the exit of the rubber 4.
boot up and over the rear cable exit of the AR Base
Replace the AR Gasket on the AR Base, over the AR Interconnect 5.
Cable, and then install the AR as described in “2. AR Flush Mount
through deck installation.”
IM Installation
With all of the AR installation options, we recommend the IM be
mounted/installed below deck in a water tight area.
To install the IM:
Open the IM enclosure 1.
by unscrewing the two
IM Enclosure Screws on
the front panel
Insert the male RJ45 2.
connector on the end
of the AR Interconnect
Cable into the female
RJ45 connector in the
middle of the inside of
the IM enclosure. The
RJ45 connector will
click into place when it
is connected correctly
Route the AR Interconnect Cable through the exit slot of the IM en-3.
closure (between the other two cables) and close the IM
Re-insert and tighten IM Enclosure Screws (from Step 1) on the IM 4.
cover. Make sure the rubber plug is snug in the stereo audio jack
after assembly