A SERVICE OF

logo

DS2100 User's Manual (Preliminary) SECTION 3: WIRING AND INSTALLATION
PAGE 3-24
3.5.2 Wiring notes for J6, J7, J9 connectors (Size C)
The connectors used on the DS2100 Size C are are formed using crimp terminals. The appropriate crimps (Molex type
42815-0031) are supplied together the floating connectors for J6, J7, and J9. These crimps are sized for a 8 AWG (8.4
mm
2
) cable with a 10 mm wire stripping. It is recommended to use the appropriate Molex crimping tool (63814-0000, or
63811-1500, or equivalent). After crimping, the contact must be inserted into the floating connector with the correct
orientation and should be held in position by the TPA (Terminal Position Assurance) jumper, as shown in Figure 3.13.
Figure 3.13 DS2100 Size C Crimp Assembly