MSR120 Programmer’s Manual UDN PM010, Rev. 1.1
Section 5 – Configuration Commands 2003/1/21
3 Send SS/ES 4 LRC not send
5 CTS disable 6 RTS disable
7 Buzzer enable 8
W
ithout JIS read head
9 Power on in protocol 0 10 Transmit TK1, TK2 and TK3
11 Self-Arm Mode enable 12 Read address = 00h
RE0 (52h 45h 00h) － Read EEPROM Data
Command Form: <09h 00h 03h 52h 45h 00h 1Dh>
1 The reader’s setting status is recorded in EEPROM. 77 bytes total.
2 The symbol “*” in this paragraph indicates “do not care”.
Byte1 and 2 in EEPROM are 00h, 13h separately. They are identical characters.
Byte 3 in EEPROM
Table 5-24. Byte 3 of EEPROM Status
Bit
7
SS&ES
Status
Bit
6
LRC
Status
Bit
5
Bit
4
Bit
3
Bit & Parity
Bit
2
Bit
1
Bit
0
Baud Rate Status
0 Not Send 0 Send 0 0 0 7 even 0 0 0 1200
1 Send 1 Not send 0 0 1 7 odd 0 0 1 2400
* * * * 0 1 0 7 mark 0 1 0 4800
* * * * 0 1 1 7 space 0 1 1 9600
* * * * 1 0 0 8 none 1 0 0 19200
Note: Bit 0-5 are reserved.
Byte 4 in EEPROM
Table 5-25. Byte 4 of EEPROM Status
Bit
7
Bit
6
Protocol
Bit
5
CTS Status
Bit
4
RTS Status
Bit 3
(always 0)
Bit
2
Bit
1
Bit
0
Transmitting Data Track
0 1 0 0 Ignore 0 Always low 0 * * 0 Not Transmit Tk1
1 0 1 1 Consider 1
Low when
transmit data
0 * * 1 Transmit Tk1
1 1 2 * * * * 0 * 0 * Not Transmit Tk2
* * * * * * * 0 * 1 * Transmit Tk2
* * * * * * * 0 0 * * Not Transmit Tk3
* * * * * * * 0 1 * * Transmit Tk3
Note: If never set “PC” command then bit 6 and bit 7 are 00, it means protocol 0.
Note: Bit 4 & 5 are reserved.
Page 5-7
Proprietary and Confidential Total 36 pages
