Omnia 6 Use and Installation Guide – Version 1.00a
92
92
Omnia-6fm System Parameters
A 'syspara' is an Omnia 6 System parameter. The System Parameters are assigned to controls which givern
overall operation, such as Input and Output Gains, Pre-emphasis/De-emphasis, etc. These parameters
would NOT be saved with individual presets, but instead are saved using the Save To Card command on
Omnia 6 Remote control, or through the Save to Card option in the front panel's System menu.
To obtain a list of all System parameters, you use the command 'sysparas', which lists all of the adjustable
parameters in a table format. Example: typing sysparas <enter> displays the following table:
1) Input Source [AES/EBU] 2) Analog Gain [0]
3) Input Left [0.0dB] 4) Input Right [0.0dB]
5) Output Left [+8.0dB] 6) Output Right [+8.0dB]
7) SCA Level [-20.0dB] 8) Composite 1 [3.98 V]
9) Pilot Level [10.0%] 10) Phase Adjust [0.0 deg]
11) Deemphasis [50uS] 12) Preemphasis [50uS]
13) Analog Phase [1] 14) LED Source [0]
15) Backlight [70] 16) Contrast [50]
17) Headphones [-8.0dB] 18) Separation [STEREO]
19) Editing Mode [EXPERT] 20) Current State [DISABLED]
21) Composite 2 [8.46 V] 22) Input Phase [NORMAL]
23) Preemphasis ['n/a'] 24) Ctrl Port Baud [19200]
25) Mono Mode [Stereo] 26) Asym Mod ['n/a']
27) Tilt Eq ['n/a'] 28) Tilt Freq ['n/a']
29) HP Filter [OUT] 30) Meta ['n/a']
31) LPF Freq ['n/a'] 32) LPF Freq ['n/a']
33) BS412 [OFF] 34) Ref. Headroom [12]
35) Ave. Power [82] 36) WB AGC [IN]
37) Phase Rot. [1]
Each 'syspara' is listed along with its currently assigned value, ie, "37) Phase Rot. [1]"
Although listed, the following 'syspara' numbers are not applicable to the Omnia 6fm:
2) Analog Gain 19) Editing Mode 28) Tilt Freq
14) LED Source 20) Current State 30) Meta
15) Backlight 26) Asym Mod 31) LPF Freq
16) Contrast 27) Tilt Eq 32) LPF Freq
