A SERVICE OF

logo

Omnia 6 Use and Installation Guide – Version 1.00a
64
64
Final Mixer (Mix)
Limiter Mixer (final mixer)
This is the final summing point for each of the multiband limiter sections before the signal reaches the final
clipper. Care should be used when adjusting this section, as too much level from any particular band could
cause an excessive amount of clipping distortion to that range of frequencies. A tribute to this fact is the
extremely fine, 0.10dB step resolution of the controls! Adjusting all 6 controls an equal amount is virtually
the same as adjusting the Clipper Drive control in the Clippers Window. If your desire is to provide some
custom “EQ” to the sound, it is better to perform that function using the drive levels in the AGC or Limiter
X-Over menus instead of the limiter mixer controls. Like the limiter threshold controls, the final limiter
mixer is mainly for minor “fine polish” to the overall sound. Adjustments in this section must be done with
care.