50
Setup
4
Fan the media (paper or transparencies), and then tap it
on a level surface to avoid media jams or skewed
printing.
Do not fan the transparency to avoid fingerprints.
NOTES:
• To optimize your printer’s performance, always use clean,
unused media.
• Be careful not to leave fingerprints on the media, which can result
in a smudged print.
• Reusing media that has been fed through the printer once (for
example, after jams) can reduce the life of the consumables and
paper path components.
5
Place the media in the tray under the hooks.
The height of media should not exceed the limit mark on the tray, or
it may cause a jam.
When loading the
recommended transparency (3M CG3710)
,
load it with the leading tape side facing up and the taped end
under the hooks. (See the illustration below.)
NOTES:
• Load media with the print side down. Most media has instructions
recommending the side to be printed first.
• Do not mix different types or thicknesses of media in the media
tray at one time; this may cause a jam.
• When using transparency, be sure to use the transparency tray.
Limit mark
Hook
Taped side facing up
