The body hose located on the back of
the vacuum cleaner carries the dirt from
the nozzle up to the dust bag. If the
hose should become clogged:
➢➢
Unplug vacuum cleaner.
➢➢
Pull open CLEAN OUT PORT and
check for clogging. Secure suction
inlet cover properly after checking.
➢➢
Disconnect body hose from wand
holder and check hose ends.
➢➢
Plug in vacuum cleaner and turn on.
➢➢
Stretch body hose in and out to
remove clogs that may not be seen.
➢➢
If clog still exists, turn vacuum
cleaner OFF and UNPLUG PO
WER
CORD
.
➢➢
Remove lower plate. See:“Removing
and Installing Lower Plate”
➢➢
Inspect inlet of nozzle hose and clear
any obstructions.
