23
For assistance, please call: 1-800-272-7033
Installation
“
Helpful functions
For checking the setup parameters or data-transmission status of the
KX-HGC200, helpful functions are available on the Broadband Networking
Gateway administration web screen.
Checking the setup parameters
1
Click [Status] on the Broadband Networking Gateway administration
web screen.
2
Check the Wireless section.
Firmware
Version
Network ID
(p. 10)
Master Node IP
Address (p. 73)
Wireless Card
State
Current version of the firmware, written in
the KX-HGC200 Flash-ROM. To update
the firmware, see p. 65.
The Network ID of the wireless network.
This ID works in order to identify a
wireless network to prevent an invalid
access to the wireless network.
The local IP address of the Master Node
in the wireless network.
connected to network:
The KX-HGC200 is connected to a
wireless network and working properly.
not connected to network:
The KX-HGC200 is not connected to any
wireless network.
TROUBLE:
The KX-HGC200 is not working properly.
The hardware or software is defected.
