15
OFF
SW position
VS/VD
● Unit Number Setting
A rotary switch is placed on the front panel. It specifies the WJ-MP204C unit number in a PS
•
Data protocol system, or camera
unit numbers in a Camera Communication Protocol system.
8 Setting the unit number
1 Turn off the power switch of the unit.
2 Use a screw driver to rotate the UNIT switch so that the arrow comes to the number you wish.
3 Turn on the power switch.
Notes:
• The unit number can be specified in the setup menu when the UNIT switch is set to "0."
• Position #9 is not allowed to be set, because it is reserved.
• Specify a unique number for each unit when connecting more than one unit in a data communication chain.
● DIP Switch Setting
A 6-bit DIP switch mounted on the rear panel specifies communication mode and sync setup. The default position is marked
with an asterisk * in the table below.
Bit 1 specifies the setup for synchronization. Refer to page 23 VS/VD IN and OUT for details.
Bit 2 is reserved.
Bit 3 specifies the communication protocol used in the system.
Bit 4 is reserved.
Bit 5 specifies the termination in the communication chain.
Bit 6 specifies RS-485 communication mode conducted via DATA port or RS-485 terminal. Set it to 4-line when PS
•
Data is
used.
