A SERVICE OF

logo

Open as PDF
next previous
-50-
Notes:
• Defaults are marked with *.
• BP stands for Bit Position.
• Full duplex is not available in a daisy chain connec-
tion. (Panasonic system controllers only)
5. Mounting the camera
(1) Aim the "START" arrow at the bent portion of the
leaf spring.
(2) Be sure to hook the fall prevention wire into the
bracket.
(3) Fix the camera to the upper base.
• Move the camera up so that its guide pins fit
into the guide holes of the upper base.
• Turn the camera counter-clockwise to the
end, viewed from the bottom.
• Fasten 3 screws.
RS485 Setting
The 4-bit DIP switch is used for
RS485 termination.
Full duplex (4 line)
*
BP 2
BP 1 Function
Switch
position
Function
Switch
position
ON
OFF
Termination ON
Termination OFF *
BP 3 BP 4
ON ON ON
OFF OFF OFF
Half duplex (2 line)
1234
ON
SW2
4-bit DIP SW
START
Leaf Spring
Bending
Fall Prevention
Wire
x3 Screws
Upper Base
Enclosure