4 - 8 Users Manual
4.4 GETTING STARTED
The various parts of this tutorial must be executed sequentially. Before startin
with this tutorial, make sure the power supply is in the local state. If the supply is
in the remote state (REM is displayed), press . If the REM text does not
disappear, the LCL key is disabled remotely by the Local Lockout (LLO) command
from the GPIB controller.
If the display shows the measured output volta
e and current of one of the output
channels, the power supply is in the OPERATE mode. Before startin
with the
tutorial, set the power supply to the STANDBY mode by pressin
the key.
Notes: • For multiple output models the selected output channel number n will
be displayed.
• For a sin
le output model the number n will not be displayed.
4.4.1 Selectin
an output channel
Make an output channel active as follows.
If you have a sin
le output model, skip the first three lines of the followin
sequence.
Press to select the desired output channel.
The display then shows the selected output channel.
Press to enable the selected output (if not already enabled).
The display shows:
Press to set the power supply to OPERATE mode.
The display shows:
OPR/STBY
SELECT
ENABLE
DISABLE
n STANDBY
ENABLED n
OPR
STBY
n xx.xxV
ENABLED n
yy.yyA
