Other connections 05
15
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Important
If you have followed the steps above, and still
can’t hear any audio output, try the following:
• Switch the amplifier off, then on again.
• Selecting another input source (like CD or
TAPE), then back to USB.
Caution
• Make sure you don’t switch off the
computer or unplug the USB cable during
playback.
• To prevent noise being output, don’t use
other software on your computer during
playback.
• Pioneer is not responsible for computer
system damage, software crashes or
failures, or any other possible computer
problems due to this configuration.
Microsoft
®
, Windows
®
XP, Windows
®
2000, Windows
®
Millennium Edition, Windows
®
98, and Windows
NT
®
are
either registered trademarks or trademarks of Microsoft
Corporation in the United States and/or other countries.
Connecting an additional
amplifier
This amplifier has more than enough power for
any home use, but it’s possible to add an
additional amplifier using the pre-outs. Make
the connections shown below to add an
amplifier to power your speakers.
• Before making or changing the
connections, switch off the power and
disconnect the power cord from the AC
outlet.
PRE
OUT
TAPE
TUNER
AUX
CD PHONO
MM/MC
L
R
GND
L
R
USB
AUDIO IN
SIGNAL
CONTROL
OUT
IN
PLAY
OUT
REC
INPUT
RL
ANALOG
This amplifier
Stereo amplifier
A9_MY.book Page 15 Tuesday, October 10, 2006 10:40 AM
