Recalling cut-off frequency
settings
% Touch CUT OFF on the sound setting
menu to select the cut-off frequency set-
ting.
Touch CUT OFF repeatedly to switch between
the following cut-off frequency settings:
CUSTOM1—CUSTOM2—CUSTOM3—AUTO
—LAST MEMORY
# You can select LASTMEMORY only whenthe
adjusted cut-off frequency settingis not memor-
ized in this unit.
# You cannot select AUTOwhen NETWORK
has been selected. (Refer to Switching theDSP
setting mode on page117.)
# When STANDARD hasbeen selected, you
cannot select AUTOif auto TA and EQ has not
been carried out.
Selecting a cut-off frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro-
duced through a LARGE speaker or subwoo-
fer.
1 Recall the cut-off frequency setting you
want to adjust.
Refer to Recalling cut-off frequency settings on
this page.
2 Touch ADJ. next to CUT OFF on the
sound setting menu.
3 Touch the speaker to be adjusted.
# You cannot select speakerswhose size is set
at OFF or LARGE.
4 Touch or to adjust parameters of
the selected speaker unit (filter).
Adjustable parameters and ranges are differ-
ent depending on each speaker unit (filter).
Parameter What itdoes
FREQUENCY
Selects cut-offfrequencies in the fol-
lowing order:
50—63—80—100—125—160—
200 (Hz)
SLOPE
Selects slopesin the followingorder:
–18— –12—–6 (dB/oct.)
When subwoofer is selected
Parameter What itdoes
FREQUENCY
Selects cut-offfrequencies in the fol-
lowing order:
50—63—80—100—125—160—
200 (Hz)
SLOPE
Selects slopesin the followingorder:
–18— –12—–6—0 (pass)(dB/oct.)
PHASE
Switches the phasebetween NOR-
MAL andREVERSE.
When tweeter isselected in the network
mode
Parameter What itdoes
FREQUENCY
Selects cut-offfrequencies in the fol-
lowing order:
1.25k—1.6k—2k—2.5k—3.15k—
4k—5k—6.3k—8k—10k—12.5k
(Hz)
SLOPE
Selects slopesin the followingorder:
–12— –6 (dB/oct.)
Audio Adjustments
En
102
Section
20
