A – Command Line Interface
Set Config Command
A-32 59022-06 A
Q
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic
reassignment of the domain ID. The
default is False.
SymbolicName Descriptive name. The default is
SANbox2.
R_A_TOV Resource Allocation Timeout Value. The
number of milliseconds the switch waits to
allow two ports to allocate enough
resources to establish a link. The default is
10000.
E_D_TOV Error Detect Timeout Value. The number
of milliseconds a port is to wait for errors to
clear. The default is 2000.
PrincipalPriority The priority used in the FC-SW-2 principal
switch selection algorithm. 1 is high, 255 is
low. The default is 254.
ConfigDescription The name for the configuration. The
default is undefined.
FC-SW-2 Compliant Propagates just the active zone set
throughout the fabric (True, compliant) or
the entire zoning database (False, non-
compliant). The default is True.
LegacyAddressFormat Available only when the FC-SW-2
Compliant parameter is False, this
parameter enables (True) or disables
(False) the use of legacy address
formatting for interoperating with non-FC-
SW-2 switches. Refer to ”FC-SW-2
Compliant” on page A-32. The default is
False.
Table A-10. Set Config Switch Parameters (Continued)
Parameter Description
