12
Note: To replace the pulley, remove the outer nut, the left
handed nut in the opposite direction (clockwise to loosen
and counterclockwise to tighen) (Fig.28).
3. Lift the belt tension and assemble the new belt by rolling it
into the big pulley from upside (Fig. 29).
Note: Heavy wet snow puts a load on belts and have to
be replaced more often.
Replace Skid Shoes
The skid shoes are located at the bottom of side panel.
Remove the 2 screws on side panel and pick up the worn skid
shoes to change (Fig. 30).
Automatic Reset
The Snow Joe SJ622E/SJ623E has a built in automatic reset
function. In the event of a major obstruction halting the auger,
simply unplug your unit, clear auger obstruction, wait 60
seconds and resume use.
Storage
1. Allow the engine to cool and clean the snow thrower
before storing or transporting. Be sure to secure the unit
while transporting.
2. Disconnect the extension cord from the snow thrower.
Inspect the extension cord closely for signs of wear or
damage. Replace it if it is worn or damaged.
3. Inspect the snow thrower carefully for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary. For repairing or replacing parts,
contact your Snow Joe dealer or Snow Joe Customer
Service at 1-866-766-9563.
4. Store the unit, along with the disconnected extension
cord, in a locked, dry place out of the reach of children to
prevent unauthorized use or damage. Cover loosely with a
tarp for added protection.
Service and Support
If your Electric Snow Thrower requires service or maintenance,
please call 1-866-766-9563 for assistance.
Model and Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
on the main cover of the unit to the left of the discharge chute.
Copy these numbers into the space provided below.
Figure 29
Figure 30
Record the following numbers from the housing or handle of your
new product:
S J 6 2 E R M
Model #:
Serial #:
