A SERVICE OF

logo

Open as PDF
next previous
6
2. Lift the chute deector and lock securely onto the
discharge chute (Fig. 6).
3. Raise or lower the chute deector to the desired height of
the snow stream and tighten the knobs (Fig. 7).
Note: Do not over tighten the knobs.
Chute Crank Assembly
1. Slide the upper chute crank through the rubber ring
located on the middle frame (Fig. 8).
2. Loosen the screw on the lower chute crank by hand
(Fig. 9).
3. Slide the upper chute crank into the lower chute crank
(Fig. 10).
4. Align the screw holes and tighten the screw by hand
(Fig. 11).
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11