226
Color Corrector
Chapter 1 MVS-8000 Functions
Spot color adjustment
You can change the color of a specified color region to a different color,
without affecting other regions. You can also mask part of such a region.
Then for the region other than the region whose color you have changed, you
can make the following corrections.
• Video signal overall gain adjustment
• Y signal gain adjustment
• Y signal offset adjustment
• C signal gain adjustment
• C signal hue adjustment
Note
This function is disabled when secondary CCR is enabled with a setup setting.
For details, see “Installation and Device Setup (Install/Unit Config Menu)” in
Chapter 16 (Volume 2).
On the MVS-8000G, this function and secondary CCR can be enabled at the
same time.
Output video processing
Carrying out the following corrections on the YUV signal.
• Video signal overall gain adjustment
• Y signal gain adjustment
• Y signal offset adjustment
• C signal gain adjustment
• C signal hue adjustment
YUV clip
For each of the luminance and color difference signals, the following
processing.
White clip: setting the maximum level of the luminance signal.
Dark clip: setting the minimum level of the luminance signal.
Positive clip: setting the maximum amplitude in the positive direction of the
color difference signal.
Negative clip: setting the maximum amplitude in the negative direction of the
color difference signal.
Copy and swap
Copying or swapping data between two color correctors (CCR1 and CCR2).
