SY-6IWM
Quick Start Guide
Setup
3
3
Quick BIOS Setup
After completion of hardware installation, turn the power switch on, then press the
<DEL>
key
while the system diagnostic is checking to enter the Award BIOS Setup program. The CMOS
SETUP UTILITY will be displayed on screen. Then follow these steps to configure the CPU
settings.
Step 1. Select [Standard CMOS Features]
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto”.
Step 2. Select [Load Optimized Defaults]
Select the “Load Optimized Defaults” menu and type “Y” at the prompt to load the BIOS
optimal setup.
Step 3. Select [Soyo Combo Feature]
Move the cursor to the
[CPU Frequency]
field to set the CPU frequency.
Available [CPU Frequency] settings on your SY-6IWM Motherboard are detailed in the
following table. If you set this field to [Manual], you are then required to fill in the next two
consecutive fields: (1) the CPU Host/PCI Clock, and (2) the CPU Ratio.
CPU Frequency (MHz) 500MHz( 66 x 7.5) 750MHz (100 x 7.5)
Manual 533MHz ( 66 x 8.0) 800MHz (100 x 8.0)
200MHz (66 x 3.0) 300MHz (100 x 3.0) 400MHz (133 x 3.0)
233MHz (66 x 3.5) 350MHz (100 x 3.5) 466MHz (133 x 3.5)
266MHz (66 x 4.0) 400MHz (100 x 4.0) 533MHz (133 x 4.0)
300MHz (66 x 4.5) 450MHz (100 x 4.5) 600MHz (133 x 4.5)
333MHz (66 x 5.0) 500MHz (100 x 5.0) 667MHz (133 x 5.0)
366MHz (66 x 5.5) 550MHz (100 x 5.5) 733MHz (133 x 5.5)
400MHz (66 x 6.0) 600MHz (100 x 6.0) 800MHz (133 x 6.0)
433MHz (66 x 6.5) 650MHz (100 x 6.5) 866MHz (133 x 6.5)
466MHz ( 66 x 7.0) 700MHz(100 x 7.0) 933MHz (133 x 7.0)
Select the working frequency of your Pentium
®
III, Pentium
®
II & Celeron processor among
these preset values.
Note: Mark the checkbox that corresponds to the working frequency of your Pentium
®
III, Pentium
®
II & Celeron processor in case the CMOS configuration should be lost.
Note:
if you use Bus Frequencies of 75 MHz, make sure that your PCI cards can cope with
the higher PCI clock.
