Diagnostic aids 3-25
Configuration menu (CONFIG MENU)
Entering Configuration Menu
1. Turn off the printer.
2. Press and hold and .
3. Turn on the printer.
4. Release the buttons when Performing Self Test displays.
The message CONFIG MENU displays on the top line of the operator panel.
Available menus
Some menus are not available, depending on the configuration of the printer.
Maintenance page count (Maint Cnt Value)
The current value for the maintenance page counter is displayed. This counter tracks printer usage. A print job
containing a single page increments the counter by one and a duplex page by two. At 300,000, the customer is
reminded that the printer requires scheduled maintenance. This counter is reset by the servicer after a 80
Scheduled Maintenance message displays and a maintenance kit is installed. See “Maintenance kit” on
page 6-1 for the part number.
Maint Cnt Value See “Maintenance page count (Maint Cnt Value)” on page 3-25
Reset Maint Cnt See “Maintenance page counter reset (Reset Maint Cnt)” on
page 3-26
Prt Quality Pgs See “Print quality pages (Prt Quality Pgs)” on page 3-26
SIZE SENSING See “SIZE SENSING” on page 3-27
Panel Menus See “Panel Menus” on page 3-27
PPDS Emulation See “PPDS Emulation” on page 3-27
Download Emuls See “Download Emuls” on page 3-27
Demo Mode See “Demo Mode” on page 3-27
Factory Defaults See “Factory Defaults” on page 3-28
Energy Conserve See “Energy Conserve” on page 3-28
EVENT LOG (print log only) See “EVENT LOG” on page 3-28
Paper Prompts See “Paper Prompts” on page 3-28
Env Prompts See “Env Prompts” on page 3-28
Jobs On Disk See “Jobs On Disk” on page 3-28
Disk Encryption See “Disk Encryption” on page 3-28
Font Sharpening See “Font Sharpening” on page 3-29
LCD Brightness See “LCD Brightness” on page 3-29
LCD Contrast See “LCD Contrast” on page 3-29
Exit Config Menu
