User's Manual
8-22
OPTIONAL DEVICES
i.LINK (IEEE1394)
i.LINK (IEEE1394) is used for high-speed data transfer for a range of compatible
devices such as
❑ Digital video cameras
❑ Hard disk drives
❑ MO drives
❑ CD-RW drives
NOTE: i.LINK uses a four-pin connector, which does not carry
electric current. External devices will need their own power supply.
Precautions
❑ Make a back-up of your data before transferring it to the computer. There is a
possibility that the original data will be damaged. There is a particular risk that
some frames will be deleted in the case of digital video transfer. TOSHIBA
assumes no liability for such loss of data.
❑ Do not transfer data in areas where static electricity is easily generated or in
areas subjected to electronic noise. Data can be destroyed.
❑ If you are transferring data through an IEEE1394 hub, do not connect or
disconnect other devices from the hub during data transfer. There is a likeli-
hood that data will be damaged. Connect all devices to the hub before you turn
on the computer’s power.
❑ You may not use any copyrighted video or music data copied from a video
camera except for your personal enjoyment.
❑ If you connect/disconnect an iLINK device to/from another iLINK device that
is currently exchanging data with the computer, data frames might be dropped.
❑ Make sure data transfer has ended or turn off the computer, before you:
• Connect/disconnect an iLINK device to/from the computer.
• Connect/disconnect an iLINK device to/from another iLINK device that is
connected to the computer.
Connecting
1. Make sure the connectors are properly aligned and plug the i.LINK (IEEE1394)
cable into the computer.
