14
STEP C-4
Attach the front suspension arms to the bulkhead by inserting a 40mm screw
pin through each pivot point. Tighten the screw pins until they are snug, but
not tight enough to bind the part.
STEP C-5
The caster blocks are labeled L and R for left and right. Position the right
caster block in the right suspension arm as shown. Insert a 24mm screw pin
through the pivot point and tighten. Repeat for the left side.
BANDIT:
Install the caster blocks with the 31.5mm suspension pins and e-clips.
STEP C-7
Press two 5x8mm oilite bushings into each of the two
steering blocks. Snap an e-clip into one of the grooves on
each suspension pin.
STEP C-8
Position a steering block in the right caster block, as shown.
Insert a 2.5x31.5mm suspension pin through the pivot
point. Secure the suspension pin by snapping an e-clip into
the other groove. Repeat for the other side.
STEP C-6
Locate the steering blocks, four 5x8mm oilite bushings, two 2.5x31.5mm
suspension pins, and four e-clips.
