7
l
Install shelf 2-3/8” from side of window
8
opening (see Figure 9).
l
Measure height of opening (see Figure 9).
Subtract 20-9116 ”
from measured height.
This will be the actual height of translucent
panel
11
l
Peel backing from seal strip (Item 8) and press
it onto side filler frame guides on each side of
unit (see Figure 12).
Figure
Figure 9
c 2-3/B”
9
l
Measure out the distance from Figure 9 and
mark it along the 20-l ‘4” side of translucent
panei. Clamp panel between a board and an
appropriate supporting surface close to mark
and cut with fine tooth saw (see Figure 10.)
Remove burrs.
CUT OFF EXCESS
LENGTH BELOW UNIT.
12
. Place unit in window by resting unit on shelf.
Push unit towards window so side angles are
sealing against the side jamb stop (see Figure
13). Slide the opened window sash firmly to
side of unit. Push unit and filler frame to
make certain the frame and unit sealing strips
are sealing
Figure 13
10
l
Lift vertically and remove panel frame from
unit. Slide translucent panel into groove in
frame, keeping honeycomb side to the face
side of frame (see Figure 11). Slide frame
back into place on unit. Panel should enter
the top angle groove.
SEAL
STRIP
c
Figure 11
SEAL STRIP
PLAIN SIDE -
HONEYCOMB SIDE
