Remove the glass from the frame opening
selected. Clear away any hardened putty.
Before sliding unit through the casement
opening, remove the bottom window bracket
(Item 3) on both sides of the unit. NOTE:
only the top screws (Item 1) need to be
removed.
Check the knurled knob screws to see that the
top mounting brackets (Item 5) are retracted
to the center of the unit. They must not inter-
fere with the window frame when the unit
is installed (see Figure 23).
6
l
Lift the unit into the window opening and
slide it back until the mounting frame comes
into contact with the window frame (see
Figure 24).
~’ -i .
i
them loose enough so there is about l/16” of
play. Tighten the bottom screws (Item 2).
This will pull the unit mounting flange tightly
to the window frame, sealing and locking the
air conditioner in place.
WIN[IOW FRAA(IE
8 . Loosen the two knurled knob screws and slide
the top mounting bracket (Item 5) toward the
outside of the unit, engaging the window
frame (see Figure 26). Tighten the knurled
knob screw in this position. This will lock the
unit in place so it cannot tilt into the room.
The installation is now complete.
9
l
WE% s)taWlM OUTSIt% OF WBJOOW
OPTIONAL MOUNTING INSTRUCTIONS
If the window thickness will not allow you to
use the four mounting brackets provided with
the unit, remove brackets and fasten flanges
of unit with sheet metal screws (see Figure 27).
These screws are not provided. The window
opening for your installation must not be
wider than 15”.
