Using the Self-Cleaning
Cycle
The Self-Cleaning cycle saves you from the toil and mess that often come with hand-cleaning
the oven interior. Like the other functions of your range, you operate the Self-Cleaning cycle
with the easy-to-use controls. Please review the instructions in this section to keep your oven
spotless.
How the cycle works
The Self-Cleaning cycle uses very high heat
to burn away soil and grease. During the
cycle, the oven gets much hotter than it does
for normal baking or broiling. This high heat
breaks up the soil or grease and burns it
away.
We recommend a 3-hour Self-Cleaning
cycle. However, you can adjust the cycle
time to the amount of soil in your oven. You
can set the cycle anywhere between 2 and 4
START
1
Time 1: Hours
3
STOP
hours. (See ‘Setting the controls” on
page 23.)
The graph at the right is representative of a
normal, 3-hour Self-Cleaning cycle. Note that
the heating stops when the 3-hour setting is
up, but it takes longer for the oven to cool
enough to unlock.
Before you start
Before you start the Self-Cleaning cycle,
make sure you:
l Hand-clean the areas shown. They do
not get hot enough during the cleaning
cycle for soil to burn away. Use hot water
and detergent or a soapy steel-wool pad
for cleaning.
Hand-clean frame
DO NOT
hand-clean seal
NOTE: DO NOT clean, move, or bend the
seal. Poor cleaning, baking, and roasting
may result.
Hand-clean door
around edge
22
