A SERVICE OF

logo

IES-5000 Series User’s Guide
Chapter 3 Hardware Installation and Connections 41
Figure 21 Installation Overview Example
You can also attach RJ-11 connectors to the Telco-50 cable and connect directly to a DSL
modem(s) or patch panel. This chapter discusses connections using MDFs. The following
sections describe typical installation scenarios.
3.5.5.1 MDF Installation Scenario A
You want to install the IES-5000 in an environment where there are no previously installed
MDFs. There is no phone service and you want to install the IES-5000 for data-access only.
No connection from the Telco-50 CO connector is necessary. G.SHDSL connections carry
data only, thus they are best suited to this installation scenario.
You may connect using an MDF or attach RJ-11 connectors to the non-IES-5000 end of the
Telco-50 cable and then connect to DSL modems directly.