3M eg4 Marine Instruments User Manual


 
Customizing set-up parameters in DMS
Display setting
053-644, Rev E Page 26 eg4 & eg3
26
The display screen is used to customize the parameters which will appear on your Edge. It is organized
by two columns, the “Display position” and the “Item to Display” and includes a “Set selected Items”
selection/drop down box. The display position indicates the order of the parameter (or item) which will
appear on the display, while the “Item to display” designates the measurement or parameter. The
example/figure below displays the SPL, Max, Min, Lavg, TWA, Dose, UL, RT, and battery time remaining
parameters to appear on the display. (Note: There are up to 18 selectable parameters. Off indicates no
item will appear.)
1. Click on the Display tab from the Edge’s Instrument Configuration panel (see 1). To customize the
display, click on either the Display position (see 1) or the Item to Display field (see 2). The field will
be shaded in blue when selected.
2. Click on the drop down box of the Set Selected Item field (see 3) and select a parameter (see 4).
3. Repeat these steps as needed to select each position.
NOTE: OFF” indicates that no item/parameter is selected.
4. To set the display features, save and send to the Edge (for more details see “saving and sending
configurations”.)
Figure 3-7: Edge display screen
1
2
3
4
4