Filter
Top Products
Toll free: 1-877-536-3976
Local: 1-408-962-0515
10
atlona.com
Command Feedback Description
x1All x1All Sets selected input to all outputs
(x3All would set input 3 to all)
x1# x1# Sets input to corresponding output
(x4# would set input 4 to output 4)
All# All# Resets all inputs to corresponding outputs
(input 3 to output 3, input 4 to output 4, etc...)
x1$ x1$ Turns off output channel
(to turn off output 3 = x3$)
All$ All$ Turns off all output channels
x1Ax2 x1Ax2 Sets audio input to selected output
(x3Ax4 = input 3 audio to output 4)
x1Ax2,x3,x4 x1Ax2,x3,x4 Sets audio input to multiple outputs
(x2Ax1,x3,x5 = input 2 audio to output 1, 3, and 5)
x1Vx2 x1Vx2 Sets video input to selected output
(x1Vx5 = input 1 video to output 5)
x1Vx2,x3,x4 x1Vx2,x3,x4 Sets video input to multiple outputs
(x4Vx1,x5,x9,x12 = input 4 video to outputs 1, 5, 9, and 12)
x1AVx2 x1AVx2 Switch input to output
(input 3 to output 5 = x3AVx5)
x1AVx2,x3,x4 x1AVx2,x3,x4 Switch input to multiple outputs
(input 3 = x3AVx1,x2)
EDID (Extended Display Identification Data)
EDID is the standard compatibility signal passed between most sources and video displays. It
allows the devices to make sure they support the same resolutions and timing.
EDID can be set up in two ways: RS-232 and the front panel.
To set up EDID through the front panel hold the <-- button for 10 seconds. Once in EDID
mode to set the matrix to default press “1”. To use Learning mode and set individual EDIDs
press “2”, the output number to copy, Enter, the input number to save to, and then press
Enter again. Repeat the learning process for all inputs until the EDID is set up as needed.
To set up EDID through RS-232 follow the steps for RS-232 set up then use the command
EDIDMx1AVx2. The x1 and x2 are place holders for output and input. If saving output 5 to
input 3 the command would be EDIDMx5AVx3. Repeat until all inputs are set up.
The AT-HDDVI1616-AM has two EDID settings: default and learning. Default saves the
settings of 1920x1200 resolution and 2 channel audio to all outputs. The learning setting will
allow for the copying of an output’s EDID to specific inputs.
Set Up