Filter
Top Products
23
BLT370
Adjusting the telephone interrupt volume
You can adjust the speaker volume in a call via your Transceiver unit.
1. Press the
[
VOL
+
]
button to increase the volume.
2. Press the
[
VOL
-
]
button to decrease the volume.
Notes:
• There are 19 volume levels where default level setting is 14 upon power up.
• Use the
[
VOL
+
]
and
[
VOL
-
]
controls to adjust the telephone call reception
volume and minimize any echo generated.
• Telephone default volume depends on each car stereo model. Please refer your
car stereo owner’s manual for further details.
Switching left or right channel output
You can switch to left or right channel output for a call.
1. Move the
[
L/R
]
selector to the right to enable right channel output.
2. Move the
[
L/R
]
selector to the left to enable left channel output.
Notes:
• If your car stereo supports telephone left/right selection, please make sure that
both units (car stereo and Transceiver unit) are set to the same output
channel.
• For left-hand drive car, the audio should preferably come out from the right
speakers and vice-versa.
Connecting an external microphone (optional)
You can connect an external microphone to the Transceiver unit via the 2.5mm
audio jack input for better voice reception. Audio input source will automatically
switch from internal microphone to external microphone. Please consult your
local authorized Clarion dealer for external microphone recommendation.
Note:
• Please use only 2.5mm jack external microphone.
5. OPERATIONS FOR
BLUETOOTH
®
AUDIO/MOBILE-
PHONE TRANSCEIVER UNIT
1EN_OM_Receiver BLT370.indd 23 8/15/07 3:10:44 PM